Here you will find information about the operation of a glasswasher.

 

Operating

 

Step 1:

  • Make sure all cables and hoses are connected according to the installation requirements. (See "Installation")
  • Start the machine by pressing the On/Off button. The appliance will automatically start filling with water and stop when the correct water level has been reached.
  • Once the water level is met the appliance will heat up the water, this process takes about 25-30 min.

ATTENTION! Do not press the washing button before this process is finished as it will cause the dishes not to be cleaned properly due to the low water temperature.

 

Step 2: (For Ultra model skip this step(See NOTES))

  • After 30-45 min the appliance is ready to wash.
  • Open the door to add the detergent to the washing tank located under the dish tray. Use the dose advised on the package of the detergent you are using.

NOTE: For the Ultra model the dispensing units will automatically add detergent and rinsing liquid. 

To adjust the dispensing quantity use the screws presented in the pictures below.(Adjustments are shown according to the direction the screw is turned)

ATTENTION! 

Make sure the rinse hose and detergent hose are properly placed in the correct cans.

    

Step 3:

  • Ensure that all dishes are rinsed and do not contain large food scraps.

ATTENTION! Food scraps may cause a blockage in the rinsing arm and/or drain filter.

  • Close the door and press the Start button, this will immediately start the washing procedure.

NOTE: The washing procedure lasts 102 seconds, 85 seconds to wash, 2 seconds to dispose of detergent, and 15 seconds to rinse.

Step 4:

  • Let the dishes cool down for 30 seconds to prevent any burn injuries, then remove the dish tray.

NOTE: As long as the start button is pressed in, the appliance will restart the program every time the door is closed.

 

Step 5:

  • (For Basic model) Turn OFF the appliance and remove the plug from the drainpipe/filter. This will drain the water in the appliance.
  • (For Ultra model) While still ON, remove the drain plug and close the door. Then turn OFF the appliance, this will activate the draining pump.
  • Finally, the appliance should be maintained and cleaned daily in order to prolong the efficiency & life. See "Cleaning" for more information about cleaning your glasswasher.