Here you will find information about installing a new glasswasher.

 

Installation

 

Requirements: 

- Socket/outlet should not be higher than 170 cm.


- Connection should be made using a 30 mA current leakage fuse as protection against current leakage danger.


- Water supply should be at ~25-50 cm from the ground, 1/2" water supply pipe & 3/4" connection attachment.


- For the Basic model(excl. Drain pump & detergent dispenser) the drain must be located lower than the machine for the water to drain with gravity. For the Ultra model(incl. Drain pump & detergent dispenser) the drain can be located up to 60 cm from the ground.

- Well ventilated area.

 

Step 1:

  • Open the box and remove the packaging material from the appliance.
  • Check the glasswasher for damage and remove the foil from stainless steel.
  • Place the appliance in the designated location.

 

Step 2:

  • Connect the water hose to the water supply and water input thread of the glasswasher. It is advised to use a 50-liter safety valve between the hose and the water supply.

NOTE: The hose can be found on the rack inside the washing chamber. 

  • Connect the drain hose to the drain. Make sure the drain is located in the correct location as mentioned in the "requirements" above.
  • Connect the blue hose to the rinsing dispenser.
  • Connect the supplied filter/weight on the other ends of the hose, this will help the hose sink to the bottom of your rinse aid bottle.

 

Step 3 (only for Ultra model):

  • Connect the transparent hose to the detergent dispenser.
  • Connect the supplied filter/weight on the other end of the hose, this will help the hose sink to the bottom of your detergent bottle.

A picture containing graphical user interface Description automatically generated

 



 



















 


Step 4:

  • Start the appliance 
  • Let it fill with water and drain 4 times, this will allow the rinse aid and detergent hoses to fill for the first wash. See "operations" for more information about operating the appliance.