How to use the appliance?
NOTE: The feeding hopper can hold 47 litres.
ATTENTION!
Potatoes should never exceed the indicated max size.
Do not try to cut hard materials, such as metal, stones or plastic.
Do not put your hands inside the feeding hopper unless the appliance is off.
Be careful when handling the blade group as it is very sharp.
This appliance should never be operated without a grounded electrical connection.
NOTE:
This appliance should only be operated by someone who has read the instruction manual.
Motor, belt or other technical repairs should only be made by experienced technicians or if instructed to by an experienced technician.
- Ensure that the blade block group is properly mounted and the machine is correctly installed before operating the appliance.
- Place the potatoes inside the feeding hopper.
- To activate the appliance, press the start button located on the control panel. This will activate the pusher drum disc. The disc then pushes the potatoes through the blade block and cuts the potato.
ATTENTION!
The feeding hopper should never be opened during operation. If the hopper is opened during operation the machine will automatically stop. The blade block group must be correctly installed in order for the machine to start.
Keep the control panel away from water.
- When the cutting process is finished, the machine can be stopped by pressing the stop button. The last potato will remain stuck on the blade block.
- Ensure that the machine is turned off and disconnect the power supply before removing the last potato from the blade.