Regeneration

The regeneration is based on rinsing the deposits using the salt tablet solution and rinsing out the absorbed calcium and magnesium ions into the sewage.

Regeneration takes place automatically in Intelligent mode. The user just has to program the tested water hardness and the system will calculate its efficiency. The display will also show the number of litres available before another regeneration cycle is necessary. 

Regeneration can be also forced in the event that the litres displayed from the appliance run out.

Immediate start:
Simply press and hold the recycle button for 5-6seconds consecutively. This will immediately start the regeneration process when activated.

Set timer start:
Press the "recycle" button 1 time, the machine will now ask to set the desired regeneration time. This time will only be taken into account once and the following regeneration time will reset to 2:00 AM.

During regeneration only hard water is available.

The regeneration process consists of 4 cycles, while the process is active the following abbreviations will display:

Regeneration cycles

90t0 = Regeneration

1. Backwashing (BW)

2. Brine and Slow Rinses (BD)

3. Fast Rinsing (RR)

4. Refilling (SR)

NOTE: The cycles can also be skipped, once the abbreviation stops blinking press the recycle button and the machine will skip to the next process of the cycle. 

(This is only recommended if the regeneration process was started by mistake!)