Here you will find information about setting up a new water softener.


First Time Use

 

  • Unpack and inspect your machine immediately after receipt. If there are any latent defects or damage to the appliance, then immediately contact your supplier. 
Save all packaging materials in case the machine needs to be returned or inspected by the freight carrier. 
  • Remove any protective film from all surfaces.


  • If your machine is supplied with a factory-fitted molded plug, you may plug the unit into a standard electrical outlet. Make sure that the voltage of the machine and the wall outlet are compatible. 
If your machine is not supplied with a factory-fitted molded plug, then a qualified electrical engineer must be contacted to wire the unit to the power supply.
  • Clean the appliance with lukewarm water and a soft cloth before using it for the first time (use water with a very mild detergent).


  • Parts that are in contact with treated water must be made of material resistant to the treated water. 

 

  • In the room for the water treatment floor drainage must be installed. The purchaser is responsible for ensuring the drainage.

Do not supply water at a temperature higher than 30C.