Here you will find information about operating a plate warmer.


 

Operation



Step 1:

  • Slide the plate holding assembly out of the cabinet.
  • Adjust the plate holding brackets by lifting the brackets and simply fitting them in a different hole, setting a bigger diameter.
  • The assembly is fitted with 24 springs, these can be disconnected to adjust the bearing capacity. When disconnecting the spring its recommended to disconnect them from the bottom.
  • Once the assembly is adjusted to your needs go ahead and place the holding assembly back into the cabinet.

 

Step 2:

  • Place your plates in the plate holding assembly and stack up to 40 plates at a time.
  • Use the power switch located at the front of the appliance to turn it "ON".
  • Turn the temperature dial to the desired temperature you would like the plates to be warmed to.

ATTENTION! The appliance surface will become hot when operating.

NOTE: The machine will now start to warm the plates, however one must take into account the various factors that affect the duration of the heating process such as: material, thickness, quantity, ambient temperature.

 

Step 3:

  • When not in use reset the temperature dial to the minimum and use the power switch to turn "OFF" the appliance.

NOTE: If the appliance will not be used for a long period its recommended to follow the "cleaning" guide to avoid rapid aging of the appliance.