Here you will find information about operating a display fridge.


 

Operations


 

Step 1:

  • Plug the appliance to a grounded socket.

ATTENTION!

Never move the appliance while operational.

  • Turn "ON" the appliance by pressing the switch next to the control panel display.


Step 2:

  • Use the "SET" button on the control panel to set the desired temperature. 
  • Using the "UP" & "DOWN" arrows increase or decrease the temperature to your liking. Press the "SET" button to confirm your choice.

ATTENTION!

After turning on the appliance its recommended to wait 2 hour before placing products inside.

 

Place products 5 cm away from the back, this will help prevent products to freeze.

 

Do not place wet boxes or products inside the appliance and make sure the products are well spaced to ease the air flow.  

 

Step 3:

  • Use the "Light" button to turn on the lights inside the cooling cabin. The button also has a secondary function, when you press the button for 6 seconds this will manually start the defrosting process.

NOTE: The defrosting process will start automatically every 6 hours.

 

We advise to refill the fridge at the end of the day to minimize the temperature change inside of the fridge. 

 

Step 4: 

  • Place your products inside of the appliance.
     

ATTENTION!
The temperature inside should stay between 0 - 10 °C. Adjust the thermostat settings accordingly. The ambient temperature will greatly affect which setting is needed to achieve this temperature range.

Do not set the thermostat to low either, this may cause ice formation and eventually damage to the appliance.

 Condensation is collected in the drain tray and should evaporate naturally.
 

  • When the appliance is not in use, turn "OFF" the appliance by pressing the green switch to the off position.
     

NOTE: If the appliance is not being used for a longer period then its recommended to remove the plug from the socket and following the "Cleaning" guide.