Here you will find information about operating a bottle cooler.


 

Operation


 

Step 1:

  • Follow the "installation" instructions carefully.
  • Switch "ON" the appliance with the switch located next to the control panel display.

 

Step 2: 

  • Hold the "SET" button for 2 seconds until the temperature on the display starts blinking.
  • Use the button to increase the temperature and the button to decrease.
  • Press the "SET" button once again to confirm your choice.

 

Step 3 (setting the compressor differential start): 

NOTE: This setting is used to set the range of temperature that is required for your personal use. The value set will allow the fridge to efficiently maintain a range of temperature that is suitable for your product and save energy by not always running the compressor.

  • Hold the "SET" button for 8 seconds until the display shows "PS".
  • Press "SET" once again, the display will show "0"
  • Set this value to "22" with the "UP" & "DOWN" buttons and press "SET" again.
  • Now the display will show the first setting "/5", use the "UP" & "DOWN" buttons to scroll until the display shows "rd" and choose it with the "SET" button.
  • Set this value to the maximum range allowed above the set temperature you have set previously in step 2.
         (For example: if the value is 2.0 and the temperature is set to 6°C, then the fridge will activate the compressor until the temperature is met and then the compressor will pause until the temperature reaches 8°C. At this moment the compressor will activate again to reset the temperature.

 

Step 4: 

  • Place your products inside of the appliance.

ATTENTION!
The temperature inside should stay between 0 - 10 °C. Adjust the thermostat settings accordingly. The ambient temperature will greatly affect which setting is needed to achieve this temperature range.

Do not set the thermostat to low either, this may cause ice formation and eventually damage to the appliance.

Condensation is collected in the drain tray and should evaporate naturally.
 

  • When the appliance is not in use, turn "OFF" the appliance by pressing the green switch to the off position.

NOTE: If the appliance is not being used for a longer period then its recommended to remove the plug from the socket and following the "Cleaning" guide.