Here you will find information about cleaning a manual feed juicer.



Cleaning

 



ATTENTION! This appliance requires daily cleaning, read through the following guide in order to prolong the life of the appliance.

 

Step 1:

  • Always switch off and disconnect the power supply before cleaning. Regularly check for any damage on the power cable or plug, if either is damaged have it repaired by a certified electrical engineer and do not use the appliance.

ATTENTION! 

Never use aggressive cleaning agents or abrasives. Do not use solvents or petrol-based cleaning agents. Some cleaning agents may leave harmful residues or cause damage to the machine. 

 

Do not use any scourer and sharp or pointed objects during cleaning, this may cause damage to the machine.

 

Never hose down the machine or immerse it in water or any other liquid, instead wipe the exterior with a damp cloth. Do not use a steamer to clean the appliance 

 

Never let the power cable or power plug get wet or damp.

 

Step 2:

  • Remove the transparent cover by unscrewing the orange hand screws and then slide off the cover.
  • Remove the waste bins on both sides of the squeezing assembly.
  • On the bottom of the squeezing assembly, gently slide the 2 peelers out of the holding brackets. Be careful as the peelers may be fragile.
  • Slide-out the knife plate which is also located in the center (handle the knife with care).
  • Undo each part of the squeezing assembly by unscrewing the orange hand screws on each rotating spinner. (You may have to remove 2 pieces at a time.)

 

Step 3: 

  • Clean and dry all parts using a brush, warm water, and a mild food-safe detergent.

ATTENTION! Do not clean parts in the dishwasher.

  • Clean the appliance with a damp cloth and make sure to dry well before reassembling.

 

Step 4:

  • Insert the squeezing assembly parts 2 at a time onto their designated spinner and secure with the orange hand screws.
  • Slide the knife plate back into place.
  • Slide the 2 peelers back into their holding bracket.
  • Place both waste bins back into their designated positions.
  • Finally slide the cover back into place and tighten the orange hands screw on each side.

ATTENTION! Make sure the cover is well placed as the machine will not operate if the safety lock button is not pressed in by the cover.